Monarch-instrument Track-It Pressure Temperature Logger Bedienungsanleitung PDF herunterladen

Rev: 0.93 05/30/13

Track-It

Pressure Temperature Logger

The Pressure Temperature Logger is a sealed (IP67) Data Logger used for

measuring air or liquid pressure and ambient temperature. The unit is self

contained in a small 316L stainless steel enclosure with a threaded ¼” NPT port

to connect to a pressure source. The Logger can operate unattended for months

or years. Recording parameters can be set in the Track-It

PC Software. The

unit can be set to record on instantly, at preset times, or on alarm conditions. Up

to 64,000 readings can be saved in non-volatile memory at intervals from 2

seconds to 24 hours. Internally there is a USB port for direct connection to a

laptop or PC, and a button and LED for user interaction as described below.

Installation: The logger screws into a ¼” NPT port. Use suitable tape or thread

sealant/dope on the threads before inserting the logger into the port. Use an

adjustable wrench on the nut to tighten the device into the port and test for leaks.

Access: To access the internals of the unit it is necessary to unscrew the lid (counterclockwise). This exposes

the control panel shown below. The function of the parts is as follows:

Push Button/LED functionality: The push button can be

used to check status or to change the state of the data logger.

For instance, it can be used to start and stop recording if

desired. This feature can also be disabled to ensure the data

logger state remains unchanged until connected to a PC.

TO CHECK STATUS

Short press and release: LED will flash in various patterns to

indicate data logger status:

The flash sequence is: Battery status > Record status >

Alarm status

One long red flash at the beginning of the flash sequence indicates low battery. (no red flash = battery ok)

One long red flash at the end of the flash sequence indicates an alarm. (no red flash = no alarm)

Slow red/green blink: Connect to PC. Unit is NOT set up or memory is full.

TO CHANGE STATE

Press and hold button, release when LED turns steady green: Changes record state on/off

Press and hold button, release when LED turns steady red: Reset alarm indication

Press and hold button, release after LED goes off: No change

1 2

Rev: 0.93 05/30/13 Track-ItTM Pressure Temperature Logger The Pressure Temperature Logger is a sealed (IP67) Data Logger used for measurin

Rev: 0.93 05/30/13 The table below summarizes the push-button / LED functionality. Serial Communication: The logger has a mini USB port

Keine Kommentare

Monarch-instrument Track-It Pressure Temperature Logger Bedienungsanleitung